Siemens SINUMERIK 802C base line User Manual

SINUMERIK 802C base line 4-1
Start-Up
Start-Up
4
4.1 General
Start–up requirements
z
The following is required:
 User Manual: Operation and Programming, SINUMERIK 802C base
line
 PC/PG (programming device) only for data saving and series start–
up
 Toolbox on CD. The CD is either supplied with the control system or
can be ordered separately.
Contents
 WINPCIN for data transfer via the V24 interface from/to
external PC/PG
 Cycle pack Turning and Milling
z
The mechanical and electrical installation of the equipment must be
completed.
Notice
For installation refer to the installation notes provided in the section 2.
z
The control system with its components has powered up without errors.
Start–up sequence
The SINUMERIK 802C base line can be strated up as follows:
1. Check whether the ENC has powered up.
2. PLC start-up
3. Technology setting
4. Set general machine data.
5. Set axis/machine–specific machine data.
 Match encoder with spindle
 Match setpoint with spindle
6. Dry run for axes and spindle(s)
7. Drive optimization
8. Complete start-up, data saving

Siemens SINUMERIK 802C base line Specifications

General

Brand	Siemens
Model	SINUMERIK 802C base line
Category	Controller
Language	English