Revision index
8
SIPROTEC PROFIBUS-DP - Communication profile
C53000-L1840-B001-03
Modified chapters /
pages
Edition Reasons of modification
general
Chap. 1
Chap. 2.1.1
Chap. 2.1.2
Chap. 2.3.2
Chap. 4.4
Chap. 4.5
Chap. 5.2
4.0
• Manual is also valid for 7ST61, 7ST63 devices with firmware from V4.0
and 7VE61, 7VE63 devices with firmware from V4.0
• Chap. “PROFIBUS communication modules” added (new HW revision 4),
the following chapter numbers moved up
• Assignment of PNO identification numbers for modules form HW rev. 4;
note to bus silent time after baud rate change added
• Setting of OLM V3 compatible modes for fibre-optical modules from HW
revision 4
• Example for routing of the OLM status indications in DIGSI added
• Precondition for time synchronization: only one master station may send
time messages in the PROFIBUS net
• new Chap. “Using SFC14 and SFC15 in STEP7”
• notes completed with OLM V3 mode and HW revisions and example for
correct parameterization with “Number of OLM” in the DP master added
Feb. 5
th
, 2004
general
Chap. 1.2.1
Chap. 3.3
Chap. 4.4.2
4.1
• Page numbering in the manual now continuous, not chapter-related any
more
• Explanation of the display of the correction values from time synchroniza-
tion messages added
• Meaning of values 0 and 3 for DP, depending on the type, added
• New value ’2’ for GlobalSection.DP_TimeSyncEnable
Dec. 8
th
, 2004
Chap. 4.4.2 4.2
• New value ’3’ for GlobalSection.DP_TimeSyncEnable
Apr. 14
th
, 2005
To Next Page
Loading...
Need help?
General