7SIPROTEC PROFIBUS-DP - Communication profile
C53000-L1840-B001-03
Revision index
Listing of the changes between the editions of this manual:
Modified chapters /
pages
Edition Reasons of modification
1.0 First edition, Doc.-No.: C53000-L1840-B001-03
Sept. 17
th
, 2001
general
Chap. 3.1.4
Chap. 3.3.3
2.0
• Manual is also valid for 6MD63 an 7SJ61...7SJ64 devices
• New chapter “Interface selection and mapping selection in DIGSI 4.3 or
higher”
• Description of Scaling indices 7 to 9 added
Jan. 14
th
, 2002
Chap. 2.7 - 2.9
Chap 1.1.3
Chap. 1.3.1
Chap. 1.2.2
Chap. 1.5
Chap. 3.2
Chap. 4.2
general
Chap. 3.4.1
3.0
• new data type definitions for “Transformer tap change command”, “Trans-
former tap position indication” and “Message block for event list”
• new chapter “Event list settings”
• Note for setting of tagging “SysIntErr” added
• new chapter “Transformer tap change commands”
• new chapter “Event list via PROFIBUS-DP”
• Type TxTap can be routed to “Destination system interface”
• max. line length for redundant optical rings an baud rates >= 500 kB/s
corrected
• Note to parameters “Retry limit” and “Slot time” added
• Manual is also valid for 7UM61 devices with firmware from V4.1
• Time interval for time synchronization of SIPROTEC devices via PROFI-
BUS-DP has to be 1 minute
Sept. 18
th
, 2002
general
Chap. 1.1.2
Chap. 3.4.1
Chap. 4.2
3.1
• Manual is also valid for 7SD5, 7SD610 devices with firmware from V4.2,
7UT613, 7UT63 devices with firmware from V4.0 and 7VK61 devices with
firmware from V4.0
• Notes for fibre-optical settings, Network size: S3 at the OLM/G12 has to
be set inversely to the value DP_OLM_NetworkSize
• Time intervals of less than 1 minute for time synchronization of SIPRO-
TEC devices are available with PROFIBUS-DP communication module
firmware from V03.01.03
• Value for “Optical receiver sensitivity” added
Feb. 28
th
, 2003
To Next Page
Loading...
Need help?
General
