Silvercrest SCW 5 A1 User Manual

SilverCrest SCW 5 A1
English - 71
Adapter for other mounting systems
The camcorder also includes an adapter for other mounting systems. You can use this
adapter to fix the camcorder with other mounting systems. You can connect this adapter to
the water-resistant case. Proceed as follows:
 Slide the adapter for other mounting systems into the adapter of the water-resistant case
until it clicks into place. Then you can use other standard mounting systems.
 Press the clip on the adapter for other mounting systems to remove the adapter for other
mounting systems from the water-resistant case.
Troubleshooting
You can solve most common problems yourself using the table below. If the problem persists
after checking the suggested solutions, please contact our Service Hotline (see page 76). Do
not attempt to repair the product yourself. Do not open the housing of the camcorder as it
contains no serviceable parts.
Error Solution
Unable to power the
camcorder on.
The battery pack is empty. Recharge the battery.
The camcorder suddenly
powers off.
The battery pack is empty. Recharge the battery.
The camcorder suddenly
powers off.
Auto power-off is enabled. Check the setting (see
page 44).
The camcorder fails to respond
and cannot be switched off.
Remove the battery pack for a few seconds and re-
insert it.
The recordings show stains or
shadows.
Use a dry, soft, line-free cloth and clean the
camcorder lens. Do not use any detergents or
chemicals.

Silvercrest SCW 5 A1 Specifications

General

Brand	Silvercrest
Model	SCW 5 A1
Category	Action Cameras
Language	English