- 6 -
Plugging in and ironing
Dry ironing is possible at all temperatures, steam iro-
ning is possible by adjusting to on the
thermostat 8.
• Insert the plug into a power socket.
Attention! Property Damage!
Should the clothing care instructions forbid ironing,
(symbol ), the clothing item may not be ironed.
If you do so, the clothing item could be permanently
damaged.
• Check the care instructions on the labels in the
garment to see whether it is suitable for being
ironed, and at which temperature setting.
• Select the best suitable temperature setting with
the thermostat 8.
Note:
While it is heating up, always place the iron on the
base 0.
If you place the iron on the ironing sole q and do
not move it, the automatic switch-off will be activa-
ted after 30 seconds (see chapter “Automatic
switch-off”) and the appliance stops heating.
The temperature control lamp 7 glows. When the
set temperature has been reached, the temperature
control lamp 7 goes out.
Symbol thermostat 8
Type of material
Acrylic, rayon
Silk, wool, polyester
blended fabrics
Cotton, linen, viscose
• Wait until the temperature control lamp 7
switches off.
• To moisten the laundry, press the button for fine
water spray 5.
This function is suitable for extremely dry and extremely
crumpled garments.
Steam ironing
• Set the steam regulator 3 to the desired steam
setting.
• The thermostat 8 must be moved to at least
adjustment range . Otherwise it cannot
produce any steam.
Ironing with steam blast
The steam blast is especially suitable for smoothing
parts of a garment that are difficult to reach.
• Slightly raise the steam iron.
• For a steam blast, press the steam blast
button 4.
Temporarily setting the steam
iron aside
Risk of fire!
NEVER leave the hot, mains-connected or switched-on
steam iron unattended.
• Set the thermostat 8 to the "MIN" position.
• Always put the steam iron on the appliance
base 0.
IB_273029_SDB2200D2_LB7 06.08.2015 7:51 Uhr Seite 6
To Next Page
Loading...
Need help?
General
