To Next Page

To Previous Page

SDB 2400 A1

Drip-Stop Function

With conventional steam irons it can happen that water drips from the iron sole

at low temperatures. This iron however possesses a new feature characteristic,

the DRIP-STOP function:

The iron automatically cuts oﬀ the supply of water for steam generation (for

steam blast and steam ironing) at low temperatures.

When this happens, a “CLICK” is to be heard. Thus, no water can drip from the

soleplate 9. You must then re-set a suitable temperature with the temperature

regulator 7. As soon as this is reached, steam production is continued.

Also when you put the steam iron down or simply let it cool down, the DRIP-STOP

function prevents dripping from the soleplate 9.

Cleaning

Self-cleaning function

NOTICE

We recommend carrying out the self-cleaning every 2 weeks. If the water ►

in your area is very hard, you should carry out the self cleaning more

frequently.

Check to ensur

e that the plug has been disconnected from the mains power 1)

socket.

Adjust the steam regulator to the position 2)

Fill the water tank to the marking MAX.3)

Insert the plug into a mains power socket.4)

Set the temperature regulator 5) 7 to the position MAX and let the iron heat up

until the control lamp “Temperature” 4 goes out.

Disconnect the plug from the mains power socket.6)

Hold the iron with one hand horizontally over a collecting bowl.7)

With the other hand press and hold the button Self Clean 8) 8. Move the

iron gently back and forth. Thereby, steam and boiling water ﬂ ows from the

steam exit holes in the sole of the iron 9. Impurities that may be present are

washed out.

Release the Self Clean 9) 8 button after about 5 - 10 seconds.

Clean the soleplate 10) 9. To do this, pass the sole plate 9 a few times back

and forth over a towel or piece of old cloth.

Allow the steam iron to cool down before putting it to one side.11)

Silvercrest SDB 2400 A1 User Manual

Other manuals for Silvercrest SDB 2400 A1