SDBB 2400 A1
GB
│
IE
│
11 ■
After use
1) Set the temperature control 6 to the min setting.
2) Remove the plug from the mains power socket.
3) Stand the steam iron on its base
9 and allow it to cool down completely.
4) Empty the water tank via the filling opening
2 and clean the soleplate 0
(see section Cleaning the housing and soleplate).
5) Place the steam iron back on its base
9.
Automatic switch-off
This steam iron is fitted with an automatic switch-off system. This stops the steam
iron from heating up if it is not moved within a certain amount of time:
■ If the iron is resting on its soleplate 0 and is not moved for about 30 sec-
onds, you will hear a warning beep and the control lamp for the automatic
switch-off 7 starts flashing. The steam iron will automatically stop heating
up. To deactivate the automatic switch-off, lift up the steam iron and move it
gently from side to side. The steam iron will heat up again.
■ If the iron is on its base
9 and is not moved for about 8 minutes, you will
hear a warning beep and the control lamp for the automatic switch-off 7
starts flashing. The steam iron will automatically stop heating up. To deacti-
vate the automatic switch-off, lift up the steam iron and move it gently from
side to side. The steam iron will heat up again.
NOTE
► The automatic switch-off is not intended as a substitute for removing the
plug from the mains power! It is merely intended to reduce the fire hazard if
you forget to switch off the steam iron.
Anti-drip system
The steam iron has an anti-drip system that automatically switches off the steam
blast at low temperatures. If this happens, you will hear a click. You must then set
a suitable temperature with the temperature control 6. As soon as this tempera-
ture is reached, steam production is resumed.
NOTE
► Wait until the set temperature has been reached and the control lamp
7
lights up before pressing the steam blast button
4 again. Otherwise,
water may drip from the soleplate
0.
To Next Page
Loading...
Need help?
General
