SDBB 2400 A1
■ 14
│
GB
│
IE
3) Mix 150 ml of tap water with 150 ml of descaling agent (ratio 1:1) and
pour the mixture into the water tank.
4) Allow the solution to work for approx. 30 minutes.
5) Hold the steam iron horizontally over a sink or suitable container.
6) Press and hold down the self clean button
q. Move the steam iron back
and forth a little so that the contents of the water tank come out of the steam
holes of the soleplate 0.
7) Release the self clean button
q as soon as the amount of water flowing
out of the steam holes on the soleplate 0 becomes noticeably less.
Empty
the remaining contents of the water tank completely into a sink via the filler
opening
2
.
NOTE
► After descaling the steam iron, always carry out two rinsing cycles using the
self clean button
q. Do not use a descaling agent without subsequently
thoroughly rinsing the water tank with tap water.
8) Use the measuring cup
w to fill the water tank up to the MAX marking with
tap water and
repeat steps 5 to 7 twice. To rinse the water tank thoroughly,
use only tap water for the two rinses.
Storage
■ Store the cooled-down appliance in a clean, dust-free and dry location.
Troubleshooting
Problem Cause Solution
The steam iron blasts
out no steam/very
little steam.
The steam iron’s wa-
ter tank is empty.
Fill the water tank with tap
water (See section Filling
the water tank).
Limescale deposits
reduce the steam
output.
Descale the steam iron (see
section Descaling the
steam iron).
The steam iron does
not get hot.
The steam iron is not
plugged in or is not
switched on.
Insert the plug into a wall
power socket and adjust the
temperature control
6 to the
desired ironing temperature.
The steam iron cannot
be switched on.
The steam iron is
defective.
Have the steam iron repaired
by a qualified technician (see
section Service).
To Next Page
Loading...
Need help?
General
