SDBS 2400 A1
■ 12 │ GB
│
IE
│
NI
│
CY
Steam ironing
1) Press the On/Off button t to turn the appliance on. The indicator lamp
integrated in the On/Off button t lights up and the “max” steam indicator
lamp w flashes.
2) Turn the temperature control 2 to set the required ironing temperature. The
temperature control 2 must be set to a minimum of
to produce steam.
3) The heat-up indicator lamp 3 lights up during heating. As soon as the heat-
up indicator lamp 3 goes out, the set temperature has been reached.
4) Press the steam strength z button to set the required steam strength:
– If the “max” steam indicator lamp w is lit up, a lot of steam will be
produced.
– If the “eco” indicator lamp q is lit up, less steam will be produced.
As soon as the “eco” q or “max” w indicator lamps light up continuously
(depending on the setting) you can start steam ironing.
5) While you are ironing, you can now press and hold the steam button 1 to
continuously spray steam onto the goods to be ironed from the sole of the
iron 6. Release the steam button 1 to stop producing steam.
NOTE
► When you press the steam button 1, it can take a few seconds until steam
is issued from the sole of the iron 6.
6) Put the iron down on the base station placement area 5 after ironing.
Set the temperature control 2 to “min”.
7) Press the On/Off button t to turn the appliance off. The indicator lamp
integrated in the On/Off button t and the “eco” q or “max” w steam
indicator lamps (depending on setting) will go out.
8) Disconnect the plug from the mains socket.
To Next Page
Loading...
Need help?
General
