Silvercrest SDBS 2400 A1 User Manual

SDBS 2400 A1
■ 16 │ GB
│
IE
│
NI
│
CY
Troubleshooting
Fault Possible cause Remedy
The appliance is
not working.
Voltage supply error. Ensure that the plug is firmly
inserted into the power socket.
The appliance is not switched on. Switch the appliance on using
the On/Off button t.
The appliance
does not produce
any/produces too
little steam.
There is not enough water in the
water tank 0.
Fill the water tank with water 0.
The appliance has not heated up
sufficiently.
Wait until the temperature indica-
tor lamp 3 goes out.
The temperature control 2 has
been set in the
–
range.
Set a temperature suitable for
steam ironing (setting range
).
The steam unit has not been used
for a long time or is being used
for the first time.
Press and hold down the steam
button 1. The steam takes a little
time until it discharges from the
sole of the iron 6.
Water drips out
of the sole of the
iron 6.
If steam ironing is paused briefly,
the cooling steam condenses
in the connecting hose 4. This
leads to drip formation.
This is normal. Hold the iron over
a collecting cloth or container
and press the steam button 1.
Steam will discharge from the
sole of the iron 6 instead of
water after a few seconds. You
can now continue ironing.
The temperature you have set is
too low for steam ironing.
Set a temperature suitable for
steam ironing (setting range
).
Wet areas occur
on the goods be-
ing ironed.
Such areas can be caused by
steam condensing on the ironing
board.
First, wipe any wet areas off
the ironing board and then iron
the wet areas on the fabric dry
without steam.
NOTE
► If you are unable to resolve the problem by taking any of the aforemen-
tioned steps, please contact the service department.

Silvercrest SDBS 2400 A1 Specifications

General

Brand	Silvercrest
Model	SDBS 2400 A1
Category	Iron
Language	English