GB
│
IE
│
NI
│
13 ■
SPBS 5000 B2
Troubleshooting
A connected device is not charging.
♦ Press the ON/OFF button
briefly to start the charging process.
♦ The power bank’s battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ The power bank can be used for end devices that require a charging current
of no more than 2,1A. If the connected end device requires a current of
more than 2,1A, the power bank will switch itself off immediately after being
switched on with the ON/OFF button
. In this case, check the power bank’s
suitability for your end device on the basis of the technical data of your end
device.
♦ Devices that require a charging current of less than 70 mA will not be charged
or only partially charged.
The power bank will not switch on.
♦ The power bank has switched itself off automatically due to overloading. You
need to charge the power bank for a short while with a USB mains adapter
before you can switch the power bank back on.
The power bank’s battery is not charging via the solar panel.
♦ Check that the solar panel
is receiving sufficient sunlight.
NOTE
► If the above-mentioned solutions do not resolve the problem, please contact
Customer Service (see chapter Service).
To Next Page
Loading...
Need help?
General
