Singer 211G146 User Manual

MOVE TO^
HIGHEST POINT
LONG-^
GROOVE
TO LEFT
LOOSEN NEEDLE
CLAMPING SCREW
INSERT NEEDLES AS
FAR POSSIBLE AND
TIGHTEN SCREW
Fig. 8* Needle Setting
HOLD THIS END
TWIRL OVER TOWARD YOU
Fig. 9. Thread Twist Determination
SETTING THE NEEDLE
1. Turn machine pulley over toward you until
needle bar is at highest position as shown in
Fig. 8.
2. Loosen needle clamping screw
3. Insert needle into needle bar to highest posi
tion, with long groove of
needle to left of opera
tor and eye of needle parallel to machine arm.
4. Tighten clamping screw.
THREAD
Left twist thread should be used in needle.
Either left or right twist thread can be used in
bobbin.
To determine thread twist, hold thread as shown
in Fig. 9. With left hand holding one end of thread,
twirl other end with thumb and forefinger of right
hand over toward you. If left
twist thread, strands
will wind tighter. If right twist thread, strands will
unwind or separate.
UPPER THREADING
Turn machine pulley over toward you until needle
bar is ot highest position.
Pass thread through threfading points as indicated
MOVE TO
HIGHEST
POINT
Threading Needle
in Fig. 10.
Draw about 2 inches of thread through needle eye
to start sewing.
Threading Tension Assembly
'BEHIND OIL PAD
Fig. 10. Upper Threading
From the library of: Superior Sewing Machine & Supply LLC

Singer 211G146 Specifications

General

Brand	Singer
Model	211G146
Category	Sewing Machine
Language	English