96
I.SEWING THE SELECTED PATTERNS
a. Single sequence sewing
After selecting stitches for a sequence, you can
add the tack stitch at the end of the sequence.
By doing so, the stitch sequence will sew one
time and then stop at the end of the sequence.
Note:
As letter stitch has buit-in tack stitch, you need not
add tack stitch at the end of sequence.
b. Repeat sequence sewing
After selecting stitches for a sequence, the
sequence will sew repeatedly if the tack stitch
is not added to the end of the sequence.
SEWING
1. Attach the Satin Foot when sewing decorative &
letter stitches.
2. Machine will start sewing from highlighted
pattern. You must shift the cursor to the pattern
where you wish to start sewing.
(When the “—” mark cursor is indicated on the
bottom of selected patterns, machine will start
from fi rst pattern.)
3. Lower the presser foot and start sewing.
Machine will indicate the sewing pattern on the
top left side of LCD.
I
J
K
K. RECALLING SELECTED PATTERNS
If you change the pattern to utility stitch,
machine will retain the combination of patterns
until the machine is turned off.
(To remain patterns if you turn off machine, see
previous page, “ To save selected patterns.)
To recall these patterns, touch the decorative
or letter stitch button. Machine will recall the
selected patterns.
(Thread tension will return to pre-set.)
J. SEWING PATTERN FROM BEGINNING
a. When you stop sewing at the middle of
selected patterns, LCD will indicate arrow
mark “
” on the left side.
This mark means that sewing is interrupted.
You can continue sewing by starting the
machine again.
b. When you have stopped sewing at the
middle of selected patterns, and if you have
raised the presser foot lifter, the arrow mark
will change to “
”,
At this time, when you start sewing again,
machine will sew from the beginning of
interrupted pattern.
c. If you want to sew from the beginning of all
patterns, shift the cursor by using the cursor
buttons. (Arrow icon will disappear)
To Next Page
Loading...
Need help?
General
