18
* The darning/ embroidery foot is an optional accessory not
included with your machine. (1)
Darning:
Install the darning plate. (2)
Remove the presser foot shank. (3)
Attach the darning/ embroidery foot to the presser foot bar.
The lever (a) should be behind the needle clamp screw (b).
Press the darning/ embroidery foot on rmly from behind with
your index nger and tighten the screw (c). (4)
For darning, rst sew around the edge of the hole (to secure
the threads). (5)
First row: Always work from left to right. Turn work by 90
degrees and sew over previous stitching. A darning hoop is
recommended for easier sewing and better results.
Note:
Free motion darning is accomplished without the sewing
machine internal feed system. Movement of the fabric is
controlled by the operator. It is necessary to coordinate
sewing speed and movement of fabric.
Stippling:
Set the machine for straight stitch. Using the optional
darning/ embroidery foot will help guide you as you sew, in
a meandering fashion to create small curving lines to hold
layers of fabric and batting together.
Free Motion Darning, Stippling
To Next Page
Loading...
Need help?
General
