DSAT-300 USER GUIDE 17
Document Rev. 1.015 DOC0594 Page 17 of 28
Restricted Proprietary and Confidential Information
11 FACTORY RESET
NOTE: A factory reset is not normally required to be performed by users.
All configuration parameters can be factory reset (returned to default values) by creating a jumper connected
between pin 4 and 5/A1 (GND) of the power connector (see Section 15.1). This will reset the unit to factory default.
This reset can only be detected and performed in the power up processing sequence, to avoid any potential
accidental reset during operations. The factory reset is followed by a reboot which will include the factory reset
indication (a double-blink of all LEDs).
12 BLUETOOTH / WI-FI
The DSAT-300 supports the use of the Parani SD200 Bluetooth Adapter and STS0062 Wi-Fi Access Point to
interface to mobile devices running RDA or STS Messenger software. A mobile device connected via Bluetooth or
Wi-Fi can:
Receive, read, send, delete and reply/forward emails to/from any valid address
Send emails directly to SkyMail (the mail program in SkyWeb)
Create, edit, save, send and delete quick mail messages
Display status and alert information and change Mission and Emergency status
To Next Page
Loading...
Need help?
General
