Smartgen HMC6 User Manual

HMC6 Power Management Controller User Manual Page 11 of 87
5.3 PARAMETERS SETTING
Press key for more than 3s to enter into user manual.
★Parameter
After entering the correct password (factory default password is 00318) you can enter parameter settings
screen.
Password can be divided into 3 levels: one highest level and two user-defined levels. After entering highest
level password, all configuration items can be set; after entering user-defined level password, users can only
configure parameters within the permission field
Parameter setting including as following,
★Bus setting
★Timers setting
★Generator setting
★Generator load setting
★GB setting
★Digital inputs setting
★Relay outputs setting
★Module setting
★Synchronization setting
★Synchronous calibration
★Local module setting
★DIN16-1 setting
★DIN16-2 setting
★DOUT16-1 setting
★DOUT16-2 setting
★LA16-1 setting
★LA16-2 setting
Example:
Return
Bus setting
>Start Delay
>Stop Delay
>Start Output Delay
>Stop Output Delay
>Start Wait Delay
>Stop Wait Delay
>Onload Stable Delay
>Transient Fault Delay
>Heavy Consumer Delay
>Alarm Start Delay
>Trigger Start Delay
Form 1: Use to scroll settings,
to enter settings (form 2), to exit
settings menu.
Timers setting >
Generator setting
Generator Load setting
Breaker setting
Input setting
Output setting
Module setting
Synchronization setting
Synchronous calibration

Smartgen HMC6 Specifications

General

Brand	Smartgen
Model	HMC6
Category	Controller
Language	English