IP C
OMMANDS
3-49
Example
IP Commands
An IP address may be used for management access to the switch over your
network. By default, the switch uses DHCP to assign IP settings to
VLAN 1 on the switch. If you wish to manually configure IP settings, you
need to change the switch’s user-specified defaults (IP address 0.0.0.0 and
netmask 255.0.0.0) to values that are compatible with your network. You
may also need to a establish a default gateway between the switch and
management stations that exist on another network segment.
SNMP traps:
Authentication: enable
Link-up-down: enable
SNMP communities:
1. private, and the privilege is read-write
2. public, and the privilege is read-only
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP logging: disabled
Console#
Command Function Mode Page
ip address Sets the IP address for this device IC 3-50
ip dhcp restart Submits a BOOTP or DCHP client request PE 3-51
To Next Page
Loading...
Need help?
General
