C
ONFIGURING
THE
S
WITCH
2-32
For example, the following screen shows the dynamic addresses for port 7.
CLI – This example also displays the address table entries for port 11.
Changing the Aging Time
You can set the aging time for entries in the dynamic address table.
Command Usage
The range for the aging time is 10 - 1000000 seconds. (The default is 300
seconds.)
Web – Click Address Table/Address Aging. Specify the new aging time,
then click “Apply.”
CLI – This example sets the aging time to 400 seconds.
Console#show bridge 1 ethernet 1/11 3-80
Interface Mac Address Vlan Type
--------- ----------------- ---- -----------------
Eth 1/11 00-10-b5-62-03-74 1 Learned
Console#
Console(config)#bridge-group 1 aging-time 400 3-82
Console(config)#
To Next Page
Need help?
General
