IP C
OMMANDS
3-53
Command Usage
A gateway must be defined if the management station is located in a
different IP segment.
Example
The following example defines a default gateway for this device:
Related Commands
show ip redirects
show ip interface
Use this command to display the settings of an IP interface.
Default Setting
All interfaces
Command Mode
Privileged Exec
Command Usage
This switch can only be assigned one IP address. This address is used
for managing the switch.
Example
Related Commands
show ip redirects
Console(config)#ip default-gateway 10.1.0.254
Console(config)#
Console#show ip interface
IP address and netmask: 10.1.0.54 255.255.255.0 on VLAN 1,
and address mode: User specified.
Console#
To Next Page
Loading...
Need help?
General
