P
RIORITY
C
OMMANDS
3-121
switchport priority default
Use this command to set a priority for incoming untagged frames, or the
priority of frames received by the device connected to the specified
interface. Use the no form to restore the default value.
Syntax
switchport priority default default-priority-id
no switchport priority default
default-priority-id - The priority number for untagged ingress traffic.
The priority is a number from 0 to 7. Seven is the highest priority.
Default Setting
The priority is not set, and the default value for untagged frames
received on the interface is zero. The switch is not instructed what to
do with the priority.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP
DSCP, and default switchport priority.
• The default port priority applies if the incoming frame is an untagged
frame received from a VLAN trunk or a static-access port. This priority
does not apply to IEEE 802.1Q VLAN tagged frames. If the incoming
frame is an IEEE 802.1Q VLAN tagged frame, the IEEE 802.1p User
Priority bits will be used.
show map ip
precedence
Shows the IP precedence map PE 3-133
show map ip dscp Shows the IP DSCP map PE 3-134
Command Function Mode Page
To Next Page
Loading...
Need help?
General
