-27-
No.PS##-OML0003-B
■[F 1] Setting of OUT1
Set output method of OUT1.
Output turns on when the pressure exceeds the set value. The default setting of output set value is a center
value of between atmospheric pressure and upper limit of the rated range.
Display color depends on OUT1 condition. The default setting of display color is as follows, green lights up
when output is turned on and red lights up when output is turned off.
For the operation of each setting item, refer to "List of output mode" on page 29.
<Operation>
Press the
or button in function selection mode to display [F 1].
Press the button.
Move on to setting of output mode.
Press the button to set. Move on to setting of reversed output.
Press the button to set. Move on to setting of pressure.
Press the button to set. Move on to setting of hysteresis.
Setting of output mode
Press the
or
button to select output mode.
Setting of reversed output
Press the
or
button to select reversed
output.
Setting of pressure
Set pressure based on setting procedure on page 22.
"P" changes to "n" while reverse output is selected. ([P_1] → [n_1])
Hysteresis mode: [P_1]
Window comparator mode: [P1L][P1H]