ACM1_TAU_UserManual_En
Page 30 of 35
SME s.p.a. Via della Tecnica 40 Z.I.
36071 ARZIGNANO (VI) ITALY
Phone +39 0444 470511 - Fax +39 0444 451803
info@grupposme.com - www.grupposme.com
4. Graphical Interface
The Controller has a number of parameters that can be calibrated using SME PC Graphical User
Interface (GUI) which is user friendly and intuitive.
These programmable parameters allow the vehicle functions and performances to be customized
to fit the needs of different applications. They are grouped into main categories (i.e. system,
motor & control, traction / pump), and into additional subgroups, each with its own programming
menu. Most of Controller default settings are fixed by SME software developers; even if user opt
to leave most of the parameters at their default values, each parameter can be calibrated inside
an allowable range.
Operator is easily guided through the process of parameter set-up and can communicate with the
controller during working operations and can analyze real-time main system variables.
Do not drive the vehicle until initial set-up has been completed.
For deep and exhaustive information about programmable parameters and
calibration procedure refer to the Interactive Documentation.
Minimum requirements
350MHz Pentium class or higher microprocessor
128MB or greater of RAM
Serial port/USB port
Graphic card 1MB
Windows XP/Vista/7/8/8.1
1024x768 resolution video adapter
Recommended requirements
1GHz Pentium class or higher microprocessor
512MB of RAM
Serial port/USB port
Graphic card 2MB
Windows XP/Vista/7/8/8.1
1024x768 resolution video adapter
To Next Page
Loading...
Need help?
General
