Snapper 1650 Series User Manual

«
■
!
8. R einstall shaft into housing and secure with re¬
taining ring.
9. Reinstall spindle assembly in mower deck but do
not tighten bolts unless center spindle was serviced.
10. Reinstall blades and pulleys and then refer to
"Replacing Belts and/or Blades and Timing Blades".
NOTE: When reinstalling gearbox and mounting
bracket assembly, extreme care should be taken to
insure that the spllned shaft of the gearbox is a free
sliding fit in the center pulley. Mis-alignment will
cause deterioration of pulley splines.
FIG. 10.6 -MOWER DRIVE BELT ARRANGEMENT
1. Mower Drive Clutch Pulley 4. Mule Drive Pulleys
2. Mower Drive Belt S. Mower Driven Pulley
3. Adjusting Bolt
FIG. 10.7-BEARING AND SEAL INSTALLED
1. Seal
2. Bearing
FIG. 10.8-SHAFT AND BEARING REMOVED

Snapper 1650 Series Specifications

General

Brand	Snapper
Model	1650 Series
Category	Lawn Mower
Language	English