Snapper 1650 Series User Manual

GEARBOX REPAIRS • 54" MOWERS
1. Remove mower from Tractor.
2. Remove gearbox from mower, Fig. 10.6.
3. Remove cover and clean grease from inside of
case.
4. Slide both retaining rings together on input shaft.
5. Remove plate and shims from case at end of input
shaft.
6. Bump shaft through bearings and gear through
opening where plate was removed until bearing can
be removed.
7. R emove bearing and lift shaft out of case through
top opening.
FIG. 10.9-GEARBOX COMPONENTS
1. Seal
2. Bearings
3. Input Gear
4. Shim
5. Plate
6. Input Shaft
7. Output Gear
8. Output Shaft
9. Bearing
10. Seal
11. Bearing
FIG. 10.10-OUTPUT SHAFT SEAL AND RETAINING
RINGS INSTALLED . . , , r ,
1. Retaining Ring
2. Seal
FIG. 10.11-OUTPUT SHAFT AND BEARING
INSTALLED IN GEARBOX
8. Remove seal, retaining ring and bearing from
case.
9. Remove gear and retaining rings from input shaft.
10. Remove retaining ring and gear from output
shaft.
11. Bump output shaft from bearings and out of
case.
12. Remove bearings, retaining rings and seal from
case.
13. Inspect all parts for wear or damage, replace as
required. Refer to Fig. 10.9, for identification and se¬
quence of parts.
14. Install retaining ring in groove in lower side of
gearbox.
15. Install seal with lip of seal toward inside of gear¬
box and install another retaining ring, Fig. 10.10.
FIG. 10.12-OUTPUT SHAFT BEARING INSTALLED
1. Bearing
2. Output Shaft
10.5 61

Snapper 1650 Series Specifications

General

Brand	Snapper
Model	1650 Series
Category	Lawn Mower
Language	English