RegularMaintenance
Oil Drain Valve Operation
1. Place a suitable container with a 4 quart capacity
under the oil drain valve (A, Figure 22 or 23).
2. Loosen or remove the dip stick (C, Figure 22 or 23).
3. Wipe oil drain valve (B, Figure 24) and cover (C) with
paper towel or rag.
NOTE: Sliding a hose with a 1/2" (12.5 mm) inside
diameter tube over the valve nipple may aid in guiding
the draining oil.
4. Rotate the drain valve (B) counter clockwise and pull
out 1/4" (6.35 mm) for engine oil to drain. Allow
ample time for complete drainage.
5. After all the oil has drained, close the oil drain valve
(B) by pushing in and rotating clockwise to close.
6. Wipe the nipple (D) with paper towel or rag. Install
the cover (C) over nipple (D).
Change Engine Oil
BRIGGS & STRATTON MODELS
Service Interval: 50 hours or once per season.
Oil Capacity: Approximately1-7/8 quarts (1.8L) without
filter change.
NOTE. Change engine off while the engine is warm. Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm.
1. Clean the area around the dip stick (C, Figure 22 or
23) and oil drain valve (A).
2. Drain engine oil. See OIL DRAIN VALVE
OPERATION above.
3. Fill the crankcase with oil. See CHECK ENGINE OIL
LEVEL.
Change Engine Oil & Filter
BRIGGS & STRATTON MODELS
Service Interval: 100 hours or once per season.
Oil Capacity: Approximately 2 quarts (1.9L) with oil filter
change.
NOTE: Change engine oil while the engine is warm. Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm.
1. Clean the area around the dip stick (C, Figure 22 or
23) and oil drain valve (A).
2. Drain engine oil. See OIL DRAIN VALVE
OPERATION above.
3. Remove the oil filter (B). Discard the filter.
4. Using a drop of oil on your finger tip, wet the rubber
gasket on the bottom of the new filter.
Valve
Valve
Figure 24. Oil Drain Valve
A. Engine Block / Valve Base
B. Oil Drain Valve
C. Cover
D. Nipple
Use0il classifiedAPIService ClassSF,
SG, SH,SJ or better with SAEViscosity:
i VI 'l I , ,
°F -20 0 20 32 40 60 80 100
°C -30 -18 -7 O 4 16 27 38
*CAUTION:Air cooled engines run hotter than automotive engines.
The use of non-synthetic multi-viscosity oils (5W-30, 1OW-3O,etc.)
in temperatures above 40° F(4°C) will result in higher than normal
oil consumption, When using a multi-viscosity oil, check oil level
more frequently.
**CAUTION: SAE30 oil, if used below 400F (4°C), will result in hard
starting and possible engine bore damage due to inadequate
lubrication.
Figure 25. Recommended Engine Oil -
Briggs & Stratton Models
5. Turn the filter clockwise until the rubber gasket meets
the filter base. Then turn 1/2 to 3/4 turn more.
6. Fill the crankcase with oil. See CHECK ENGINE OIL
LEVEL.
7. Test run the engine to check for leaks. Stop the
engine for 1 minute, then recheck the oil level.
24
To Next Page
Loading...
Need help?
General
