Disclaimers
Important Notice
Copyright © SolarEdge Technologies Inc. All rights reserved.
No part of this document may be reproduced, stored in a retrieval system or transmitted, in any form or
by any means, electronic, mechanical, photographic, magnetic or otherwise, without the prior written
permission of SolarEdge Technologies Inc. also efeed to heei as “olaEdge.
This document is solely for the use of SolarEdge customers and employees.
The material furnished in this document is believed to be accurate and reliable. However, SolarEdge
assumes no responsibility for the use of this material. SolarEdge reserves the right to make changes to the
material at any time and without notice. You may refer to the SolarEdge web site (
www.solaredge.com)
for the most updated version of this and other documents.
All company and brand products and service names are trademarks or registered trademarks of their
respective holders.
Patent marking notice:
http://www.solaredge.com/groups/patent
The general terms and conditions of purchase of SolarEdge products shall apply.
The content of these documents is continually reviewed and amended, where necessary. However,
discrepancies cannot be excluded. No guarantee is made for the completeness of these documents.
Please note: This product is intended to provide remote shutdown of the SolarEdge PV harvesting system,
to enable safer access to a building in the event of fire. This product DOES NOT reduce the risk of fire or
protect firefighters or others accessing a building in the event of a fire.
If the RS485 communication between the firefighter gateway and the SolarEdge inverter(s) is
disconnected for any reason (including fire), the firefighter gateway LCD will display "No
Communication" or "Partial Com.". In this case, the firefighter gateway cannot be relied upon to
disconnect the SolarEdge PV harvesting system.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment OFF and ON, you are encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance may void the
use’s authoity to opeate the euipet.
To Next Page
Loading...
Need help?
General