Help Guide
Interchangeable Lens Digital Camera
ILCE-6100 α6100
Wireless Flash
There are two methods for wireless flash shooting: light-signal flash shooting that uses the light of the flash attached to
the camera as a signal light, and radio-signal flash shooting that uses wireless communication. To perform radio-signal
flash shooting, use a compatible flash or the Wireless Radio Commander (sold separately). For details on how to set
each method, refer to the instruction manual of the flash or the Wireless Radio Commander.
Menu item details
Off:
Does not use the wireless flash function.
On:
Uses the wireless flash function to make an external flash or flashes emit light at a distance from the camera.
Setting of the AEL button
We recommend that you set MENU →
(Camera Settings2) → [ Custom Key] → [AEL Button] to [AEL hold]
when performing wireless flash shooting.
Note
Wireless flash shooting cannot be performed with the camera’s built-in flash.
The off-camera flash may emit light after receiving a light signal from a flash used as the controller of another camera. If this
occurs, change the channel of your flash. For details on how to change the channel, refer to the instruction manual for the flash.
For the flash that is compatible with wireless flash shooting, visit the Sony website, or consult your Sony dealer or local
authorized Sony service facility.
5-009-879-11(1) Copyright 2019 Sony Corporation
MENU →
(Camera Settings1) → [Wireless Flash] → [On].
1
Remove the shoe cap from the camera, and then attach the flash or the Wireless Radio Commander.
When performing light-signal wireless flash shooting, set the attached flash as the controller.
When performing radio-signal wireless flash shooting with a flash attached to the camera, set the attached flash
as the commander.
2
Set up an off-camera flash that is set to wireless mode, or that is attached to the Wireless Radio Receiver
(sold separately).
Press the AEL button on the camera to perform a test flashing.
3
To Next Page
Loading...
Need help?
General
