Notes on the tape counter
• The tape counter indicates the recording or playback time. Use it as a guide. There will
be a time lag of several seconds from the actual time. To set the counter to zero, press
COUNTER RESET.
• If the tape is recorded in SP and LP modes mixed, the tape counter shows incorrect
recording time. When you intend to edit the tape using the tape counter as a guide,
record in same (SP or LP) mode.
Note on beep sound
As indicated with _ in the illustrations, a beep sounds when you turn the power on or
when you start recording and two beeps sound when yon stop recording, confirming
the operation. Several beeps also sound as a warning of any unusual condition of the
camcorder. Note that the beep sound is not recorded on the tape. If you do not want to
hear the beep sound, change the BEEP setting to OFF.
Note on the AUTO DATE feature
The clock is set to East Coast Standard Time at the factor}'. You can reset the clock.
The AUTO DATE feature shows the date automatically once a day. However, the date
may automatically appear more than once a day when:
- yon reset the date and time.
- you eject and insert the tape again.
- you stop recording within 10 seconds.
m
o
X_
ca
o
.=
Zooming is a recording technique that lets you change the size of the subject in the
scene. For more professional-looking recordings, use the zoom sparingly.
"T" side: for telephoto (subject appears closer)
'q_'/" side: for wide-angle (subject appears farther away)
11
To Next Page
Loading...
Need help?
General