Before using your camcorder, you first need to charge and install the battery pack. To
charge the battery pack, use the supplied AC power adaptor.
1
Charge the batter]," pack on a flat place without vibration.
(1) Connect the AC power adaptor to the wall outlet.
(2} Align the right side of the battery pack with the line on the AC power adaptor,
then slide the battery pack in the direction of the arrow.
(3) Set the selector to CHARGE. The CHARGE lamp (orange) lights up. Charging
begins.
When charging is completed, the CHARGE lamp goes out. Unplug the unit from the
wall outlet, and then remove the battery pack and install it on the camcorder.
2 3
.jw
Charging Time
Battery pack NP-33(su)plied)lNP_0D] NP_78 I NP-68 ) NP-C65 I NP-60D
Charging time*(min) _ 215 190 170 125 105 90
*Approximate minutes to charge an empty battery pack using the supplied AC power
adaptor. (Lower temperatures require a longer charging time.)
Battery life
CCD-TRV12/TRV112
Battery pack
While LCD open 21
recording" LCD dose
While playing back on
LCD_I
NP-33(suppliedJ _P-98/98D NP-g0/BOD NP-78 NP-68 NP-C65 NP-60D
65 (30) 225 (120) 195 (t05) 180 (100) 140 (75) 115 (60) 100 (55)
85 (40) 300 (160) 255 (140) 230 (125) 175 (95) 155 (85) 130 (70)
65 225 195 180 140 115 100
To Next Page
Loading...
Need help?
General