You can choose any of the following power sources for your camcorder: battery pack,
the house current, alkaline battery and 12/24 V car battery. Choose the appropriate
power source depending on where you want to use your cameorder.
Power source
Indoors House current
Outdoor Battery pack
Size AA (LR 6) Alkaline baitery
In the car 12 V or 24 V car battery
Note on power sources
Accessory to be used
Supplied AC power adaptor
Battery pack (Ni-Cd type)
Battery case (supplied) except CCD TRV112/TRV2!2
DC pack DCP-77
Disconnecting the power source or removing the battery pack during recording or
playback may damage the inserted tape. If this happens, restore the power supply again
immediately.
This mark indicates that this product is a genuine accessory for Sony video product.
When purchasing Sony video products, Sony recommends that you purchase
accessories with this "GENUINE VIDEO ACCESSORIES" mark.
P
3*
D.
o
"O
o
1
O
To use the supplied AC power adaptor:
(1) Connect the power cord to a wall outlet. Insert the top of the connecting plate
of the AC power adaptor into the top of the battery mounting surface. Push the
connecting plate so that it attaches firmly. Make sure that you hear clicks twice.
(2) Set the selector to VTR (DC OUT).
2
WARNING
Power cord must only be changed at qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source as long as it is connectL_t to the
wall outlet, even if the set itself has been turned off.
19
To Next Page
Loading...
Need help?
General