53
Advanced Playback Operations
[a][b][c]
JUL 5 2000JUL 4 2000 DEC 31 2000
You can automatically search for the point where the recording date changes and start
playback from that point (Date search). Use the Remote Commander for this operation.
Use this function to check where recording dates change or to edit the tape at each
recording date.
(1) Set the POWER switch to VTR.
(2) Press SEARCH MODE on the Remote Commander repeatedly, until the date
search indicator appears.
The indicator changes as follows:
DATE SEARCH t PHOTO SEARCH t PHOTO SCAN
(3) When the current position is [b], press . to search towards [a] or press >
to search towards [c]. Your camcorder automatically starts playback at the
point where the date changes.
Each time you press . or >, the camcorder searches for the previous or
next date.
To stop searching
Press x.
Searching a recording by date
– Date search
3
=+
2
SEARCH
MODE
DATE
00
SEARCH
DATE
01
SEARCH
To Next Page
Loading...
Need help?
General