1-1
SECTION 1
SERVICE NOTE
DSR-PDX10/PDX10P
COVER
COVER
1-1. NOTE FOR REPAIR
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)
When remove a connector, donāt pull at wire of connector.
It is possible that a wire is snapped.
When installing a connector, donāt press down at wire of connector.
It is possible that a wire is snapped.