Sony HDCU2500 User Manual

22
COAXIAL Connection System
The camera and the camera control unit is connected via two
coaxial cables in place of an optical fiber cable, and
transmission is achieved with HD-SDI.
Unlike fiber transmission, Dual Link formats cannot be used.
Note
Do not connect an optical fiber cable in a COAXIAL connection
system. If an optical fiber cable is connected, the SHORT LED
of the CABLE ALARM indicators will flash on the front panel of
the camera control unit.
Connection example
Settings
Camera
MAINTENANCE menu, <SDI OUT> page:
Set COAX MODE to ON.
Set SDI-2 OUT/IN to HD TRUNK/RET IN.
Camera control unit
Format: Select a Single Link format.
CCU CONFIGURATION menu, <TRANSMIT> page: Set
CABLE to COAX.
INCOM
INTERCOM 1
PROD
LEVEL
REAR
FRONT
MIC
ON
OFF ENG
OFF
+48V
MIC
FRONT MIC
PROMPTER
/GEN
LOCK
RET CTRL
AUDIO IN
CH1 CH2
TEST
OUT
SDI
MONI
DC IN 10.5-17V
LINE
OFF
+48V
MIC
AES/EBU
LINE
INCOM
INTERCOM 2
EARPHONE
REMOTE
DC OUT
CRANETRACKER
PROD
LEVEL
REAR
FRONT
MIC
ON
OFF ENG
HD TRUNK OUT
HD PROMPTER IN
SDI 1
SDI 2
HDC2500
HDCU2500
BNC cable (HD-SDI)
BNC cable (HD-SDI)
DC power
1)
1) A dedicated power source is required for the camera. No
power is supplied from the camera control unit.

Sony HDCU2500 Specifications

General

Brand	Sony
Model	HDCU2500
Category	Control Unit
Language	English