24
GB
Do not place the system near heat
sources or in a place subject to direct
sunlight, excessive dust, or mechanical
shock.
Do not place the Bar Speaker, Subwoofer
and Surround Speakers on a soft surface
(rugs, blankets, etc.) or place anything at
the rear of the Bar Speaker, Subwoofer
and Surround Speakers that might block
the ventilation holes and cause
malfunctions.
If the system is being used in combination
with a TV, VCR, or tape deck, noise may
result and picture quality may be
affected. In this case, place the system
away from the TV, VCR, or tape deck.
Use caution when placing the system on a
surface that has been specially treated
(with wax, oil, polish, etc.), as staining or
discoloration of the surface may result.
Take care to avoid any possible injury
from the corners of the Bar Speaker,
Subwoofer and Surround Speakers.
Keep 3 cm or more space under the Bar
Speaker and Surround Speakers when
you hang it on a wall.
On operation
Before connecting other device, be sure to
turn off and unplug the system.
If you encounter color irregularity
on a nearby TV screen
Color irregularities may be observed on
certain types of TV.
If color irregularity is observed...
Turn off the TV, then turn it on again after
15 to 30 minutes.
If color irregularity is observed again...
Place the system further away from the
TV.
On cleaning
Clean the system with a soft, dry cloth. Do
not use any type of abrasive pad, scouring
powder, or solvent such as alcohol or
benzine.
If you have any question or problem
concerning your system, please consult
your nearest Sony dealer.
On handling the Subwoofer
Do not place your hand into the slit of the
Subwoofer when lifting it. The speaker
driver may be damaged. When lifting it,
hold the bottom of the Subwoofer.
Troubleshooting
If you experience any of the following
difficulties while using the system, use
this troubleshooting guide to help
remedy the problem before requesting
repairs. Should any problem persist,
consult your nearest Sony dealer.
The power does not turn on.
Make sure the AC power cord
(mains lead) is connected securely.
The system does not work normally.
Disconnect the AC power cord
(mains lead) from the wall outlet
(mains), then reconnect after
several minutes.
The system is turned off automatically.
The auto standby function is
working. Set “ASTBY” in “SYS >” to
“OFF” (page 20).
The system does not turn on even
when the TV is turned on.
Set “HDMI>” – “CTRL” to “ON”
(page 19). The TV must support the
Control for HDMI function (page 21).
For details, refer to the operating
instructions of your TV.
Check the speaker settings of the
TV. The system power syncs with
the speaker settings of the TV.
For details, refer to the operating
instructions of your TV.
General
To Next Page
Loading...
Need help?
General
Weight and Dimensions
