Sony SRS-M30 User Manual

16
Customizing the equalizer curve
— EQ3
“CUSTOM” of EQ3 allows you to make your
own equalizer settings.
1 Select a source, then press the select
button repeatedly to select “EQ3.”
2 Rotate the volume control dial to
select “CUSTOM.”
3 Press the select button repeatedly
until “LOW,” “MID” or “HI” appears.
4 Rotate the volume control dial to
adjust the selected item.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 3 and 4 to adjust the equalizer
curve.
To restore the factory-set equalizer curve,
press and hold the select button before the
setting is complete.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Tip
Other equalizer types are also adjustable.
Adjusting setup items — SET
1 Press and hold the select button.
The setup display appears.
2 Press the select button repeatedly
until the desired item appears.
3 Rotate the volume control dial to
select the setting (example “ON” or
“OFF”).
4 Press and hold the select button.
The setup is complete and the display returns
to normal play/reception mode.
Note
Displayed items will differ, depending on the source
and setting.
The following items can be set (follow the page
reference for details):
“
z” indicates the default settings.
CLOCK-ADJ (Clock Adjust) (page 6)
CT*
1
(Clock Time)
To set “CT-ON” or “CT-OFF” (
z) (page 12, 13).
BEEP
To set “BEEP-ON” (z) or “BEEP-OFF.”
AUX-A*
2
(AUX Audio)
To turn the AUX source display “AUX-A-ON”
(
z) or “AUX-A-OFF” (page 17).
A.OFF (Auto Off)
To shut off automatically after a desired time
when the unit is turned off,
– “A.OFF-NO” (
z), “A.OFF-30S (Seconds),”
“A.OFF-30M (Minutes)” or “A.OFF-60M
(Minutes).”
REAR/SUB*
2
To switch the audio output.
– “REAR-OUT” (
z): to output to a power
amplifier.
– “SUB-OUT”: to output to a subwoofer.
DEMO
(Demonstration)
To set “DEMO-ON” (z) or “DEMO-OFF.”
DIMMER
To change the brightness of the display.
– “DIMMER-AT” (
z): to dim the display
automatically when you turn lights on.
– “DIMMER-OFF”: to deactivate the dimmer.
– “DIMMER-ON”: to dim the display.
CONTRAST
To adjust the contrast of the display.
The contrast level is adjustable in 7 steps.
ILLUMI (Illumination)
To change the illumination color: “ILLUMI-1”
(
z) or “ILLUMI-2.”

Sony SRS-M30 Specifications

General

Magnet type	Neodymium
Audio output channels	2.0 channels
Speakers	Active
Output power	2 W
Dimensions (WxDxH)	59 x 45 x 105 mm
Magnetically shielded	Yes
Impedance	8 Ω
Frequency range	250 - 20000 Hz
Product color	Silver
Number of batteries supported	3
Connector(s)	Straight stereo-mini

Weight and Dimensions

Depth	34 mm
Width	59 mm
Height	105 mm
Weight	200 g
Diameter	39 mm
Cord length	0.75 m