25Projecting the Picture on the Screen
Projecting
6 Turn the focus ring to adjust the focus.
Adjust to obtain sharp focus.
1 Press the I/1 (on/standby) switch.
A message “POWER OFF?” appears on the screen.
2 Press the I/1 switch again.
The ON/STANDBY indicator flashes in green and the fan continues to run
to reduce the internal heat. First, the ON/STANDBY indicator flashes
quickly, during which you will not be able to light up the ON/STANDBY
indicator with the I/1 switch.
3 Unplug the AC power cord from the wall outlet after the fan
stops running and the ON/STANDBY indicator lights in red.
You can turn off the projector by holding the I/1 (on/standby) switch for about
one second, instead of performing the above steps.
Turning Off the Power
Focus ring
To Next Page
Loading...
