SpringWell SPRW-UV5-15 User Manual

13|Page
Operaon
UV systems come with a feature laden controller that incorporates both the lamp driver (ballast)
and control features in one water-ght case. Four main controllers are available (depending on
your model). All four models feature a power factor corrected, constant current lamp driver with
a universal power input.
Please Note: While the LED or display screen is red and the buzzer is sounding the water from
the system should NOT be consumed. If any water does pass through the system during this
period, please follow the disinfecon procedure as outlined in this manual before the water is
consumed. For UV4 and UV5 systems, even though they have a visual and audible warning built
into the controller, a green LED or status screen does not necessarily indicate that the water
coming from this system is in fact potable (safe to drink). These systems do not measure the level
of disinfecon; they simply measure the “on-o” status of the lamp. Please have your water
checked for microbiological contaminants on a regular basis.
UV4 Controllers
UV4
Series
UV4-C
Series
Simplisc in operaon, these systems feature a tri-
colour LED that indicang system status and a 4-digit
display to indicate lamp life remaining. Pressing the
buon will change the display to indicate total running
me. When the UV lamp is on and within its operang
age, the LED will be green. When the UV lamp is not on
or the lamp life has expired, the LED will be illuminated
red and an audible buzzer will be sounding. To remedy
this condion, the UV lamp must be replaced with a
new genuine SpringWell UV lamp.
UV5 & UV6 Controllers
UV5/6
Series
UV5/6-C
Series
A full colour LCD screen provides the user with a
detailed descripon of the system’s performance in
addion to providing any applicable fault messages
and system diagnoscs. The controllers used in both
the UV5 and UV6 are idencal. The dierence is that
the UV6 series of products includes a UV intensity
monitor. All UV5 and UV6 controllers include an
“innite expandability port” located on the right side
of the controller. Simply plug in an oponal UV sensor
module into the expandability port of a UV5 controller
and the system will now monitor the UV intensity of
the system!
UV5 and UV6 Power-up Sequence
On start up, the controller will run through a diagnosc start-up and the sequence will be
displayed as follows on the colour LCD:

SpringWell SPRW-UV5-15 Specifications

General

Brand	SpringWell
Model	SPRW-UV5-15
Category	Accessories
Language	English