SpringWell SPRW-UV5-15 User Manual

14|Page
Next, the controller checks for and inializes any oponal modules that may be aached to the system.
Oponal Modules Check
- UV Sensor
- Solenoid
- 4-20 mA
- WIFI
- Remote Alarm
- Flow Meter
OR
A nal module screen is displayed showing which specic modules were inialized.
The controller then displays the lamp opmizaon screen for 60 seconds to allow the lamp to
reach its opmum output. Finally, a nal “start-up complete” screen is displayed. The system will
now be ready to disinfect water ow.
all detected modules lamp reaching max output successful start-up
UV5 Operaonal Screens
On systems without the UV monitor, the default screen shows the Home Screen. At any point
during operaon the user is able to scroll through the Home Screen, Lamp life remaining, QR
Code, Contact Info and Maintenance Parts screens by pressing the buon located on the front
of the controller.
UV6 Operaonal Screens
On systems with the UV monitor, the system will display the same screens as on the UV5 except the
UV Intensity replaces the home screen. The UV Intensity screen displays the level of UV light detected
by the sensor. UV intensity can be aected by poor water quality, scaling on the quartz sleeve and/or
sensor, lamp failure or lamp expiring. The following screens show the UV Intensity dropping.

SpringWell SPRW-UV5-15 Specifications

General

Brand	SpringWell
Model	SPRW-UV5-15
Category	Accessories
Language	English