ST STM32 Nucleo-64-P User Manual

UM2206 Rev 3 9/55
UM2206 Quick start
54
8 Quick start
This section describes how to start a development quickly using the STM32 Nucleo-64-P
board.
Before installing and using the product, accept the Evaluation Product License Agreement
from the www.st.com/epla webpage.
8.1 Getting started
The STM32 Nucleo-64-P board is a low-cost and easy-to-use development kit to quickly
evaluate and start a development with an STM32 microcontroller in QFP64 package. To
start using this board, follow the steps below:
1. Check the jumper position on the board, as showed in the Table 4: Default jumper
settings
2. For a correct identification of all device interfaces from the host PC, install the Nucleo
USB driver available on the www.st.com/ stm32nucleo webpage, prior connecting the
board.
3. To power the board connect the Nucleo-64-P board to a PC with a USB cable ‘type A to
micro-B’ through the USB connector CN1. As a result the green LED LD3 (5
V PWR)
lights up, LD1 (COM) and green LED LD4 blink.
4. Press user button B1 (blue).
5. Observe that the blinking frequency of the three green LED LD4 changes, by clicking
on the button B1.
6. The software demonstration and the several software examples, that allow the user to
use the Nucleo features, are available at the www.st.com/stm32nucleo webpage.
7. Develop an application using the available examples.
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

ST STM32 Nucleo-64-P Specifications

General

Brand	ST
Model	STM32 Nucleo-64-P
Category	Motherboard
Language	English