Be very careful when cutting grass on
slopes: avoid abrupt starts and stops,
do not run the machine transversally
to the slope but run from top to bottom
and vice versa.
Apply the parking brake when you park the
machine.
The machine may not be driven on slo-
pes greater than 10º in any direction.
Reduce the speed on slopes and when
making sharp turns in order to retain
control of the machine and reduce the
risk of overturning.
Do not turn the steering wheel to full
lock when driving at full speed. The ma-
chine may overturn.
Keep hands and feet well away from the
articulated steering joint and seat bra-
cket. Risk of crushing injuries.
7.2 COMBINED USE OF ACCESSORIES
For the combined use of accessories,
please refer to the “TABLE FOR THE
CORRECT COMBINATION OF ACCES-
SORIES” in section “0 TECHNICAL
DATA TABLE”
7.3 REFUELLING
Use only the prescribed types of fuel.
For the capacity of the fuel tank and the type of
fuel to be used, please refer to “0 TECHNICAL
DATA TABLE”.
The transparency of the tank allows the user to
check the level easily.
Do not use rapeseed-based biodiesel
(RME).
NOTE! Further information on the type
of fuel to be used can be obtained from
the engine supplier.
Filling the fuel tank over the MAX level
Fuel increases in volume when it heats
up.
To ll up with fuel:
1. Open the bonnet (see 5.2).
2. Open the fuel cap (23:A).
3. Fill with fuel up to the MAX level.
4. Close the fuel cap.
Temperatures below 0°C.
Use winter fuel or add kerosene when the ambient
temperature drops below 0°C
For the quantity of kerosene to mix with
the fuel, adhere to the parameters pro-
vided in the table below.
Ambient opera-
ting temperature
in °C
Quantity of kerosene to be
added
Summer fuel Winter fuel
From 0 to -10 20 % -
From -10 to -15 30 % -
From -15 to -20 50 % 20 %
From -20 to -30 - 50 %
7.4 FUEL CIRCUIT PRIMING
Prime the fuel circuit in the following cases:
• When the fuel tank has run dry or air has got
into the fuel circuit.
• After replacing the lter.
To prime the circuit:
1. Fill the fuel tank.
2. Pump the hand pump (24:A) to send fuel
through the transparent lter (24:B) until it
is almost full (usually 4 or 5 pumping actions
suce).
7.5 CHECKING THE ENGINE OIL LEVEL (25)
The machine is delivered complete with engine oil.
Before starting the machine check the
level of the engine oil.
To check / top up the engine oil, see
9.5.1.
7.6 CHECKING THE TRANSMISSION FLUID
LEVEL
see 9.7.1.
To Next Page
Loading...
Need help?
General
