14 TROUBLESHOOTING
Problem Probable cause Remedy
1. The starter motor does not
turn.
Battery not charged enough. Recharge the at battery.
Battery not connected. Check the connections.
Fuse 20A blown. Replace the fuse
2. The starter motor turns but
the engine doesn't start.
With the ignition key in the
start position, the starter
motor turns but the engine
doesn't start.
Fuel cock closed. Open the fuel cock.
No fuel ow. - Check the fuel level in the tank.
- Check the fuel lter.
or engine runs irregularly.
Carburettor problems. Clean or replace the air lter.
4. Drop in engine performance
during cutting.
Forward speed too high in rela-
tion to the cutting height.
Reduce the forward speed and/
or raise the cutting height.
5 The oil buzzer sounds while
working.
Problems of engine lubrication. - “Turn o the machine imme-
diately.
- Replace the oil (if the problem
persists, contact an authorized
service center). “””
5. The engine stops for no
apparent reason.
- Fuel tank empty.
- Try to restart the engine.
Fill the fuel tank (if the problem
persists, contact an authorised
assistance centre).
6. Uneven cutting. Check the tyre pressure.
The cutting device sharpness
level is low.
Contact an authorised assistan-
ce centre.
Forward speed too high in
relation to the height of the grass
being cut.
Reduce the forward speed and/
or raise the cutting height.
The cutting means assembly is
full of grass.
- Wait for the grass to dry.
- Clean the cutting means
assembly.
7. Abnormal vibration during
use.
- Unbalanced cutting devices.
- Slackened cutting devices.
- loose components.
- possible damage.
Contact an authorised assistan-
ce centre for inspection, replace-
ment or repair operations.
8. With the engine running,
activation of the traction pedal
does not move the machine.
"Disengage transmission” lever in
the disengaged position.
Engage the transmission.
To Next Page
Loading...
Need help?
General
