Stiga A1500 User Manual

15EN
4. INSTALLATION
4.3. VERIFICATION OF THE INSTALLATION REQUIREMENTS
Below the procedures to check the necessary requirements and prepare the garden before proceeding
with the installation are described.
4.3.1. GARDEN VERIFICATION:
• Carry out a survey of the entire area for a correct detection of the state of the garden, of any
obstacles and areas to be excluded.
• Check whether the lawn to be mowed is even, free of holes, stones or other obstacles and if
necessary carry out any necessary remediation work.
• Level the ground to prevent puddles from forming after a rainfall.
• At the rst installation, the initial height of the grass must be within the operating range of the robot
lawn mower: 20-60mm. If necessary, prepare the garden using a traditional lawn mower.
The robot lawn mower works using a satellite signal. The accuracy of the satellite signal can be aected by:
• The presence of obstacles around the perimeter of the installation or within the work area, such
as: trees with dense foliage, hedges, boundary walls, metal fences, buildings and reective surfaces
such as glass or metal walls.
• Adverse weather conditions, such as dense fog, dense cloud cover, heavy rainfall or snowfall.
In the event of any malfunction, move the satellite reference station to another area free of obstacles and/
or exclude the area from the work area of the robot lawn mower.
4.3.2. CHECKS FOR THE INSTALLATION OF THE DOCKING STATION AND POWER SUPPLY:
ELECTRICAL HAZARD:
A socket must have been prepared
near the installation area to connect
it to electricity. Make sure that
connection to the power supply
network conforms to laws in force of
the Country where it is used.
ELECTRICAL HAZARD:
Do not connect the power supply
to an electrical outlet if the plug or
the cable is damaged.
Do not connect or touch a
damaged cable before it is
disconnected from the power
supply.
A damaged cable can lead to
contact with live parts.
ELECTRICAL HAZARD:
The circuit provided must be
protected by a residual current
device (RCD) with an activation
current not exceeding 30 mA.
Procedure:
• Prepare a at area where the docking station (A) can be positioned, preferably in an area of the
garden where the sky is fully visible and close to an electrical outlet.
• Make sure that the space for installing the docking station is sucient, in order to have an
obstacle-free zone at least 1.5 metres wide and at least 3 metres long in front of it. the ground must
be perfectly at and compact in order to avoid deformation of the surface of the docking station.

Stiga A1500 Specifications

General

Brand	Stiga
Model	A1500
Category	Lawn Mower
Language	English