EN - 6
5.2.2
1.
IMPORTANT The motor must always be
running with the drive disengaged.
IMPORTANT To prevent damage to
the transmission, do not pull the machine
backwards with the drive engaged.
5.3
5.3.1
The operator presence lever (Fig.13.A) enables
5.3.2 Power button
1. Machine power-on.
NOTE The machine power-on is
possible only if the operator presence
lever and the drive lever are released.
NOTE In case the machine is not
operated, the display turns o after 15
seconds and the above-mentioned
operation must be carried out again.
2. Cutting means engagement.
NOTE The cutting means
engagement is possible only by
pressing the operator presence lever
against the handle (see par. 6.3).
3. Cutting means disengagement. With
5.3.3
a.
presence levers (Fig.13.A)
against the handle.
b.
levers (Fig.13.B) against the handle.
1. Maximum speed
2. Minimum speed
NOTE The last speed level selected
remains set after the machine shutdown.
IMPORTANT To prevent damage to
the transmission, do not pull the machine
backwards with the drive engaged.
5.3.4
operator presence levers are released.
NOTE It is not recommended to use the
“ECO” function in heavy grass cutting conditions
(cutting of dense, high, humid grass).
5.4
Do this when the cutting means is stationary.
•
• The cutting height is adjusted by the levers
(Fig.15.A). The four wheels must be adjusted to
the same height.
•
• The cutting height is adjusted by pressing
the button (Fig.16.A) and, using the handgrip
(Fig.16.B), lifting or lowering the chassis to the
desired position.
To Next Page
Loading...
Need help?
General
