EN - 8
Cooling air ducts Not clogged.
Machine
6.2.2 Machine operating test
Action Result
1. Start the machine
(par. 6.3).
2. Release both control
levers (Fig.27.A).
1. The cutting means
should move.
2. The levers should
neutral position, the
Advanced Series
1. Start the machine
(par. 6.3).
2. Enable the cutting
3. Release both ope-
rator presence
levers (Fig.28.A).
1. The display turns o
and the machine is
ready for use.
2.
3. The levers should
neutral position, the
1. Start the machine
(par. 6.3).
2. Engage the drive lever
(par. 5.2.2 / 5.3.3).
3. Disengage the
drive lever.
1. The wheels should
move the machine
forward.
2.
Test driving
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
a service centre to have it checked and repaired if ne-
cessary.
6.3
NOTE Start up the machine on a at
surface without obstacles or high grass.
1. Open the hatch for accessing the battery com-
partment (Fig.21.A).
2.
3.
4a.
•
4b.
•
•
6.4 OPERATION
IMPORTANT When working, always keep
a safe distance from the cutting means,
given by the length of the handle.
IMPORTANT If the motor stops because
it is overheated while mowing, you must wait
approximately 5 minutes before restarting it.
6.4.1 Grass cutting
1.
2.
3.
For side discharge:
cut grass is not discharged on the grass still to be cut.
For mulching or rear grass discharge:
•
grass height per single pass (Fig.25.0).
•
6.4.2
To Next Page
Loading...
Need help?
General
