HT-KM
English
12
Cutting above obstacles
The unit's long reach makes it possible
to prune branches that are overhanging
obstacles, such as rivers or lakes. The
tool angle in this case depends on the
position of the branch.
Cutting from a lift bucket
The unit's long reach enables cutting to
be performed next to the trunk without
the risk of the lift bucket damaging other
branches. The tool angle in this case
depends on the position of the branch.
30° angle drive (special accessory)
The angle drive keeps the cutting
attachment at an angle of 30° to the
drive tube.
The angle drive may be adjusted on the
drive tube to the following positions only:
1 For cross-cutting vertical branches
and bushes.
2 For a better view of the cutting
attachment.
KombiEngines
Only KombiEngines supplied by STIHL
or expressly approved by STIHL for use
with the specific model are authorized.
Only use this KombiTool with the
following KombiEngines:
STIHL KM 55 R, KM 56 R, KM 85 R,
KM 90 R, KM 94 R, KM 110 R,
KM 130 R
WARNING
For machines with a loop handle, the clip
(barrier bar) must be installed.
Approved KombiEngines
To Next Page
Loading...
Need help?
General
