Stihl MS 192 T Manual

37MS 192 T
: Place the engine pan on the
sealing surface of the cylinder,
ensuring that the lug (arrow)
faces the cylindrical crankshaft
stub (1).
217RA148 TG
1
So that the sealing compound is
distributed uniformly, fit the screws
and gently press the engine pan
down.
: Tighten the screws (arrows)
down crosswise.
217RA111 TG
– Tightening torques, b 3.5
Avoid damage to the crankshaft
stub.
– Clean the crankshaft stub with
standard solvent-based
degreasant not containing any
chlorinated or halogenated
hydrocarbons.
– Install the engine, b 8.4.2
– Reassemble remaining parts in
reverse order.
– Remove the engine, b 8.4.1
– Remove the crankshaft, b 8.5.1
: Remove the ball bearing (1) and
washer.
1
217RA118 TG
: Remove the ball bearing (1) and
washer.
376RA121 TG
1
: The crankshaft (1), connecting
rod (2), the needle bearing
between them and the needle
bearing (3) form an inseparable
unit. They must always be
replaced as a complete unit.
The deep groove ball bearings and
376RA128 TG
13 2
oil seals must always be replaced
when installing a new crankshaft.
– Before installing the crankshaft,
clean it with standard solvent-
based degreasant not containing
any chlorinated or halogenated
hydrocarbons.
: Fit the washer (1).
376RA133 TG
1
8.5.3 Crankshaft / Bearing

Stihl MS 192 T Specifications

General

Brand	Stihl
Model	MS 192 T
Category	Chainsaw
Language	English