0458-795-8621-B
46
English
18 Switching the Chain Saw On and Off
18.1 Switching On
WARNING
Never operate your chain saw if it is modified, damaged,
improperly adjusted or maintained, not completely and
securely assembled or not functioning properly, @ 6.4. To
reduce the risk of personal injury, always wear proper
clothing and protective apparel, including proper eye
protection, when operating your chain saw, @ 6.3.
Before switching on:
► Make sure you have a secure and firm footing.
► Stand upright.
► Always hold and operate the chain saw with your right
hand firmly on the rear or control handle and your left hand
firmly on the front handle. Always hold the chain saw with
two hands in this manner, whether you are right-handed or
left-handed.
To switch the chain saw on:
► Disengage the chain brake, @ 16.2.
► Depress and hold the trigger switch lockout (1) with your
thumb.
► While holding the trigger switch lockout, squeeze the
trigger switch (2) with your index finger.
The saw chain will start rotating.
The motor will not switch on unless the hand guard is set to
the position and the trigger switch lockout and trigger
switch are pressed at the same time. Once the trigger switch
is activated and the saw is running, the operator need not
continue to hold down the trigger switch lockout.
18.2 Switching Off
WARNING
The saw chain will continue to rotate for a short while after
the trigger switch is released. To avoid serious or fatal injury,
avoid contact with the moving saw chain. To reduce the risk
of personal injury from unintended activation or
unauthorized use, switch off the motor, ensure the chain has
stopped, engage the chain brake and remove the battery
before transporting or putting the chain saw down.
To switch the chain saw off:
► Release the trigger switch so that it springs back to the
locked position. In the locked position, activation of the
trigger switch is once again blocked by the trigger switch
lockout.
The saw chain will continue to rotate for a short while after
the trigger switch is released. Take care to avoid contact
after releasing the trigger switch and when setting down
the chain saw.
19.1 Checking the Operation of the Chain Brake
WARNING
Operating the saw with a missing, damaged, modified or
improperly maintained chain brake increases the risk of
severe or fatal injury from kickback. Never attempt to modify
or disable the chain brake. Never operate a saw if the chain
brake has been modified or does not function properly. If you
detect a change in the operating characteristics of the chain
brake, have your saw serviced immediately by an authorized
STIHL servicing dealer.
18 Switching the Chain Saw On and Off
19 Checking the Chain Saw
To Next Page
Loading...
Need help?
General
