0458-729-8621-A
11
English
6 IMPORTANT SAFETY INSTRUCTIONS
longer function properly and safety devices may be
inoperative. To reduce the risk of personal injury and
property damage:
– Take the chain saw to your authorized STIHL
servicing dealer to be checked before further
operation.
￭ Genuine STIHL replacement parts are specifically
designed to match your chain saw model and meet safety
and performance requirements. Use of parts that are not
authorized or approved by STIHL may cause serious or
fatal injury or property damage.
– STIHL recommends that only identical STIHL
replacement parts be used for repair or
maintenance.
6.5 Power Supply Cord and Extension Cord
WARNING
￭ Using a damaged power supply cord, plug, or extension
cord may result in fire, electric shock and other personal
injury or property damage. To reduce these risks:
– Do not abrade, crush, jerk, or otherwise abuse or
misuse the power supply cord and extension cord.
Protect them from heat, oil and sharp edges.
– If the power supply cord becomes damaged, have it
replaced by an authorized STIHL servicing dealer
before use. A damaged power supply cord must be
replaced with an identical STIHL replacement part.
– Unplug the power supply cord and extension cord
when the chain saw is not in use.
– Never yank or jerk the power supply cord or
extension cord to disconnect. To unplug, grasp the
plug, not the power supply cord or extension cord.
– Make sure the power supply cord and extension cord
are positioned and secured or marked so that they
will not be stepped on, tripped over, come in contact
with sharp objects, moving parts, or otherwise be
subjected to damage or stress.
￭ To reduce the risk of electric shock:
– Use only extension cords that are intended for
outdoor use, identified in the U.S. by the following
marking: "Suitable for use with outdoor appliances.
Store indoors while not in use."
– The chain saw must be connected to an electrical
outlet equipped with a Ground Fault Circuit
Interruptor (GFCI) or Residual Current Device (RCD)
with a maximum differential tripping current of
30 mA.
￭ This power tool has a polarized plug (one blade is wider
than the other). This plug will fit in a polarized outlet only
one way. To reduce the risk of electric shock:
– Do not change the plug in any way.
– If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified
electrician to install the proper outlet.
￭ Overloading an extension cord can result in overheating
and fire. To reduce these risks:
– Be sure to use an extension cord heavy enough to
carry the current your electric saw will draw. Read
and follow the minimum wire size requirements for
120 Volt appliances set out in, @ 22.2.
– Use of an extension cord not meeting the minimum
wire size will cause a drop in wire voltage and result
in a loss of power and overheating.
– Never use an extension cord with a wattage or
electrical rating lower than the wattage or electrical
rating on your chain saw's rating plate.
– Never use an extension cord if the blades on its plug
are different from the blades on the power tool plug
in number, size or shape.
– Never connect more than one chain saw or other
device to a single extension cord.
– Check the chain saw’s power supply
cord, plug and your extension cord
regularly for damage. If it becomes
damaged, immediately disconnect the
chain saw from the power supply. Never
use a damaged power supply cord, plug
or extension cord.
To Next Page
Loading...
Need help?
General
