0458-729-8621-A
35
English
12 The Chain Brake
► Turn the oil filler cap counterclockwise until it can be
removed.
► Remove the oil filler cap and fill the tank with chain oil.
► Take care not to spill chain oil while refilling the tank.
► Do not overfill the tank. Leave approximately 0.5 in.
(13 mm) of air space.
To close the tank:
► Position the oil filler cap on the oil tank filler neck and
press it down while turning it clockwise until it is tight.
12.1 Engaging the Chain Brake
WARNING
The chain brake will operate only if it has been properly
maintained and the front hand guard has not been modified,
@ 7.2.
WARNING
No chain brake device prevents kickback. This device is
designed to reduce the risk of kickback injury, if activated, in
certain kickback situations. For the chain brake to reduce
the risk of kickback injury, it must be properly maintained
and in good working order, @ 7.2.
Engaging the chain brake locks the chain. To manually
engage the chain brake:
► Push the front hand guard to the position, away from the
front handle.
You will hear an audible click when the front hand guard
reaches the locked position.
In the event of a kickback, the brake is designed to engage
if the left hand contacts the front hand guard and pushes it
forward.
The chain brake is also designed to be activated by the
inertia of the front hand guard if the forces are sufficiently
high. When the brake is activated by inertia, the hand guard
accelerates toward the bar nose, even if your hand is not
behind the hand guard, e.g., during a felling back cut.
12.2 Disengaging the Chain Brake
WARNING
Before disengaging the chain brake and switching on your
chain saw, be sure that the guide bar and saw chain are
clear of you and all other obstructions and objects, including
the ground, @ 6.6.
12 The Chain Brake
To Next Page
Loading...
Need help?
General
