IMPREZA U.S.A. (E)
3-18
NOTE
D The wiper operates only when the ignition switch is in the “ON”
or “ACC” position.
D Clean your wiper blades and window glass periodically with a
washer solution to prevent streaking, and to remove accumulations
of road salt or road film. Keep the washer button depressed at least
for 1 second so that washer solution will be sprinkled all over the
windshield or rear window.
D Grease, wax, insects or other material on the windshield or the
wiper blades results in jerky wiper operation and streaking on the
glass. If you cannot remove those streaks after operating the
washer or if the wiper operation is jerky, clean the outer surface of
the windshield or rear window and the wiper blades using a sponge
or soft cloth with a neutral detergent or mild-abrasive cleaner. After
cleaning, rinse the window glass and wiper blades with clean water.
The glass is clean if no beads form on the glass when you rinse with
water.
D If you cannot eliminate the streaking even after following this pro-
cedure, replace the wiper blades with new ones. Refer to the “Wiper
blade replacement” section (chapter 10) for replacement instruc-
tions.
J Windshield wiper and washer switches
B Windshield wipers
HB2019BB
To Next Page
Loading...
Need help?
General
